82572 Compartment lock
New
Product profile
The compartment lock is made of stainless steel and is particularly suitable for use in locking systems, letterboxes, cabinets and furniture. It has an opening and a feedback contact (locking status) and can be controlled via an I/O module (82610) or an I/O extender (82630). With the built-in voltage regulator and low power consumption, it also works without any problems with longer cables.
The compartment lock also has a mechanical emergency release. It is very robust, has a long service life and can withstand very high tensile forces. The lock can be installed vertically or horizontally.
The IP66 protection makes the compartment lock suitable for both indoor and outdoor applications.
The mounting kit (82576) for the compartment lock, which can be ordered separately, is ideal for installation on wooden surfaces.
Standard version
- Dimensions: 79 mm x 82 mm x 19.2 mm
- Weight: 367.5 g
- Signal: 8 V - 24 V dc (1 s, max. 100 mA)
- Response time (change of state): 0.3 s
- Operating temperature: -20 °C ~ +60 °C
- Relative humidity: 5 % ~ 85 %
- Weather protection: IP66
- Closing cycles: 500,000
- Door weight: up to 50 kg
- Resistance: 2726 N
- Terminal assignment:
- red = +VDC;
- black = GND;
- white = feedback (NO);
- blue = feedback (COM).
Scope of supply
- 1x compartment lock
- 2x screws
Important note
When installing in a compartment with a swing door, use only where the door is wider than
20 cm!
Explanation:
In order for the locking hook to engage correctly With the retaining bracket, the retaining bracket (normally mounted on the door) must only come into contact With the locking hook at a flat angle (as indicated in the instructions). lt is therefore strongly recommended that the retaining bracket, normally mounted on the door, is only mounted on doors that are wider than 20 cm.
b
Downloads
Product information
Product data sheetTechnical documentation
Dimensional drawing